Tuesday, April 24, 2007

TRG Esc 2

New japanese game - Part 2 of TRG Esc 2

Click here to play

1 comments:

Anonymous said...

TRG Esc 2 Walkthrough

Ahead of you is a piece of paper. Click on it to zoom in.

There are four small black squares. Click each one twice to take them.

This reveals an electric circuit board.

Zoom out and pick up the piece of paper that’s fallen on the floor.

Click on the far right-hand side of the screen

This takes you to a blank wall with a thin line just off the middle.

Click at the bottom of the line (it’s only a few pixels big so be patient)

You should reveal a piece of paper. Get it.

Click the top of the line at the top of the screen and another piece of paper will be revealed.

Go back left to the original screen with the circuit board on it.

One of the pieces of paper you picked up will fit over the circuit board and reveal a set of numbers - note the sequence.

Examine the 4 black pieces - they are magnets. Click on each one individually. Note its number and its colour.

Now click on the corresponding buttons on the circuit board in the order that it showed on the piece of paper.

Each button should be changed to the colour that it was on the magnets. It is different in every game.

You have to do it in order.

If it’s right all the buttons will flash blue. Click the handle to reveal a screwdriver.

Zoom out and click the side of the screen until you see a big silver locker. Click it until it falls to the floor.

Use the screwdriver to remove the screws.

Go down the ladder until you can see all of the ladder.

Click the right hand side of the middle rung to reveal some more screws.

Undo them

Take the rung out.

Go to the bottom of the ladder and you will see a locked door.

Click at the top and left of the door. You’ll be presented with a new angle. Click on the right hand side of the screen and some brakets will be revealed.

Examine the rung of the ladder you picked up earlier. Click the bottom of it to reveal a torch. Examine the torch and click on the blue strip to remove it from the torch.

Place the magnets on the torch and now you’ve got a magnety catcher thing. Go back to the circuit board and examine the hole where you got the screwdriver from. You may have to shine the torch in first and then place the magnets back on. You will see a key, use the magnet-torch to get it.

Go back to the underground ladder and before you climb down there should be 4 holes in the middle of the square frame of the hole. Use the brackets on here. Then place the ladder rung on the brackets and the locker should go up again.

Use the key on the small door.

Climb to the top of the ladder.

Get the Key.

Use it on the lock next to the key.

Escape.

Post a Comment